Smart1 Water Treatment Controller by Aquatrac

ACCURATE CONDUCTIVITY CONTROL = REDUCED OPERATING COSTS

Smart1's control chemical and water costs by maximizing the cooling tower cycles of concentration
Accurate set and dead-band levels control bleed and chemical feed power relays for dosing and conductivity precision
Bleed solenoid and chemical feed pump are all that's required for complete control
 

FULLY FEATURED FOR FAULT FREE OPERATION

Each Smart1 includes a flow sensor and a set of LED's for power, low conductivity, no flow, alarm and relays energized. A test switch independantly turns on both relays
Rugged, NEMA 4X, lockable enclosure supplied with pre-wired outlets
Smart1's have the features which limit costs for installation, operation and mantenance while controlling chemical usage
 

AC COUPLED, MICROCONTROLLER STABILIZED SENSOR DRIVE

Fully AC coupled drive eliminates sensor pitting and drift. Microcontroller synthesized frequency lock sets drive accuracy for repeatable control
Controller software supports user specific upgrade functions without cost penalties
 

FEED TIMER HALTS THE COST OF OVER-DOSING

Set the chemical feed time-out from 0 to 90 minutes to stop the feed pump if the target conductivity is not achieved
 

WIDE RANGING AND SIMPLE CALIBRATION

Control ranges from 500 to 20,000uS fit site specific conditions. One point calibration for simple set-ups